RAPIX eHub Sensor Multiplexor

Key Features

  • Expands eHub smart ports to allow 3 occupancy sensors to be connected to each of 4 ports (12 sensors in total)
  • Connects directly to a RAPIX eHub using common RJ45 patch leads
  • Powered by the RAPIX eHub
  • No terminal blocks – uses RJ45 cables to connect to the eHub and sensors
  • Drives an ‘Identify LED’ in supported occupancy sensors
  • Short circuit and reverse polarity protected
  • Light and small, 80g, 138 mm x 63 mm x 31 mm
  • SELV only, no mains segregation requirements
  • Screw holes and slots for easy mounting or tie-down
SKU DGOZ-MPX-PIR6 Category Tags ,


The eHub Sensor Multiplexor is used as part of a RAPIX Lighting Control System to allow up to three occupancy sensors to be connected to a smart input channel on an eHub.

The device connects to a RAPIX eHub via a Cat5/6 cable and is powered via the eHub.

Programming for sensor behaviour uses the RAPIX Addressing or RAPIX Integrator software.

  • Only suitable for sensors with a dry contact, normally open output
  • Not suitable for push button or latched (toggle) switches


Data Sheet


Scroll to Top