DALI-2 40-series Switch Input – 2 Gang

A switch input unit that can utilise up to 2 Clipsal 40-series 5041NMS, allowing use in the RAPIX Lighting Control System or with other DALI-2 compliant Application Controllers.

For the added resilience of RAPIX, the switch input unit allows 40-series push buttons to act as RAPIX DALI-2 Application Controllers, performing switching, dimming, timing, group control, scene control and similar functions.

DALI System Commissioning

This product is set up using any DALI-2 commissioning software that supports DALI-2 Control Device instance types 1 (push buttons) and feature type 32 (feedback). For the higher resilience of RAPIX and to use the built-in Application Controller, the free RAPIX Addressing or RAPIX Integrator software should be used.

DALI-2 Instances

The product has 2 instances, all are Type 1 Push Button.

All instances are always present, irrespective of whether a Clipsal 5041NMS is physically connected or not. If an input has nothing connected, then that instance is present but has no effect.

This product range also supports DALI-2 Feature Type 32 (Feedback on Instance Level) for indicator control. Each instance can have the red or blue indicator selected according to configuration settings and DALI-2 commands

RAPIX Zero-Commissioning: Out-of-box Functions

This product supports RAPIX Zero-Commissioning out-of-box functions:

• Push / release to transmit Broadcast ON/OFF. Push and hold to DIM UP/DOWN & release to terminate the dimming.

Connecting to the DALI Line

The DGOZ-IC-2 includes a 2-wire cable to allow connection to a DALI line.

Connecting the 5041NMS

A Clipsal 5041NMS has a ribbon cable with connector. This plugs directly into a socket on the RAPIX DALI-2 40-series Switch Input.

DALI-2 Feature 32 Capabilities

This product has the following capabilities:

• feedbackCapability: Bit 6: common brightness control.
• feedbackActiveBrightness and feedbackInactiveBrightness are binary: brightness is either on or off.
• feebackColourCapability supports R and B, with 1-bit resolutions (Red and Blue). Combinations of Red and Blue are not possible.
• Feedback is only supported for “Feature on Instance Level”.
• Although both Red and Blue LEDs may be activated, only one or the other may be active on an instance at any time. Mixing of colours is not supported.