Our RAPIX DALI-2 blind and shutter relay is now available. We have developed this DALI-2 blind and shutter relay to be used on all DALI-2 systems as well as our RAPIX system. The DALI-2 blind and shutter relay can control blinds, shutters, curtains, tilt motors and may also be used for garage panel and roller […]
Tag: DALI
Greater Shepparton Secondary College – Project Snapshot
Project Overview Client: Greater Shepparton Secondary College Developer: Victorian School Building Authority Builder: Hansen Yuncken Architect: Gray Puksand Electrical Engineer: WSP Electrical Contractor: Watters Electrical Systems Integrator: Watters Electrical RAPIX DALI Solution Overview 20+ RAPIX DALI-2 4 Channel Zone Controllers 700+ RAPIX DALI XI Presence Sensors Wall Switches Throughout All general lighting […]
How to control trailing edge phase dimmable light fittings on a DALI Lighting Control System
The question always gets asked: how do we control our trailing edge phase dimmable light fittings on a DALI Lighting Control System? The answer is much easier than sometimes thought. Every lighting control system is different, and in the past some of the more traditional lighting control systems had a dedicated leading edge, trailing edge […]
3 Key Factors to Ensure the Highest Quality DALI Line
3 Key Factors To Ensure The Highest Quality DALI Line Rev 1 Download and save for later… Download
New Product Release: DALI-2 Low Power Voltage Free Relay
Ozuno is pleased to announce the general release of the new Low Power Voltage Free Relay. This relay is designed for electrical safety isolation of the output terminals from DALI, and is suitable for use in systems that have a SELV interface suitable for relay contact connection. The relay is rated to 1 A for […]
Step out of the Darkness with DALI Brightness Levels
Check any DALI configuration software or documentation and chances are that the term Direct Arc Power will be used at some point. For example: a DALI Short address (single Luminaire) or DALI Group Address (a number of luminaries) can be set to go to a particular light level by issuing a Direct Arc Power Command. […]
DALI Relays – A Leap Forward not Backwards
Suitable control gear is available for just about every type of light source: Fluoro, LED, Emergency, LV and even incandescent? So why would you ever need to use a DALI Relay? Integrate existing non-dimmed light fittings in a refurbishment project; Control new non-DALI light fittings that the client ‘just has to have’; Banks or circuits of […]
10 Point DALI Check List – Do This First And Save Time
So you’ve run all the Mains and the DALI bus wiring to all the DALI fitting on a DALI Line. What should your check list be before you start the commissioning process? Here is a 10 point DALI check list that will make every DALI installation faster and more reliable. Confirm that there are no […]
Speed Up DALI Addressing And Commissioning
One of the first things you notice when installing and configuring a DALI installation – known as assigning DALI Addresses: The process for applying and then identifying which control gear has which DALI Short Address can take a significant amount of time. Why Does DALI Addressing Take So Long? The reason is that every DALI […]
DALI Cable Requirements: Insulation
A DALI communication line runs at ELV – so why do I need to use LV double insulated cable? The DALI bus voltage (the DALI Line) is in the range 9.5 V dc – 22.5 V dc. This is normally considered Extra Low Voltage, or ELV: a voltage not exceeding 50 V ac or 120 […]